LVD Strippit PPEB/8 120 BH 08 135 Ton x 8' CNC Hydraulic Press Brake (2000)

LVD Strippit PPEB/8 120 BH 08 135 Ton x 8' CNC Hydraulic Press Brake (2000)

Built by Strippit LVD in Belgium
460V, 3-Phase, 32 kW
Estimated at 17,000 lbs, 11.5ft tall, 10ft wide and 6ft deep
The Z1 and Z2 axes are not working as VFDs were bad and were not available at
the time.
All Hydraulics are in good order.
No dies included. It does have European to American punch extensions included
It has 8 axes (left ram, right ram, backgage forward and back, left finger position,
right finger position, right finger forward and back, entire backgauge up and
down, with crowning.
The PEB120 LVD is an 8+1 type.
Y1 and Y2 are the main vertical press cylinders (sometimes call R1 and
R2 for Ram)
Z-Axis is left-to-right side shift of back gauge. Z1 and Z2 are the
horizontal shifts for the two back gauges
X-Axis is the forward and back of the back gauge. If two then X1 and X2.
R-Axis is the Up/DWN of the back gauge fingers. R1 is Left and R2 is
Right.
V-Axis is the Crowning Axis
Power release clamp for the punch die
10ft wide x 6ft deep 11.5 tall