Edge Technologies FMB Turbo 5-55 Bar Feeder (2018)

Edge Technologies FMB Turbo 5-55 Bar Feeder (2018)

Configured to a Hardinge Conquest 42 lathe
Channel Guide Set 42mm
Collet (dia 3/4” hex)
Bushing (dia 3/4” hex)
Channel Guide Set 20mm
Collet (dia ½” hex)
Bushing (dia ½” hex)
Spindle Liner 20mm
Air knife is included whatever that is
Added Collets ¼, 5/16, 3/8, 7/16, ½, 9/16, 5/8, 11/16, ¾, 7/8, 1, 1-11/16, 1-1/8, 1-1/4, 1-3/8, 1-1/2
We have both big and little pushers/channel guide sets
Bar diameter capacity-no bar preparation: 5 mm to 51 mm (.196” to 2.000”)
Bar diameter capacity-with bar preparation: 5 mm to 55 mm (.196” to 2.165”)
Maximum bar length: 3800 mm (12 feet 5 inches)
Minimum bar length: 1000 mm (39.400”)
Maximum remnant length: 530 mm (20.800”)
Magazine rack capacity: 11”
Magazine rack angle: adjustable 6-20°
Bar loading cycle time: 35 seconds for 12-foot bar
Material straightness specification: .007” TIR/foot of material (V blocks, 3 points equidistant)
Feed force (pusher torque): max 750 N, adjustable
Forward feed rate: 2360 inches/minute max, adjustable
In-feed rate: 0-1650 inches/minute max, adjustable
Power consumption: 1.5 kW – (2 kVA)
Operating voltage: 230V/60Hz 3-phase
Control voltage: 24V DC
Oil capacity: 80 liters (22 gallons)
Oil viscosity: ISO 150 cST
Compressed air supply: 6 bar (90 psi)
Compressed air consumption: approx. 10 liters per loading cycle
Machine weight (without oil): 6,160 lbs

Bar diameter capacity: 5 mm to 55 mm (.196” to 2.165”)
Automatic loading magazine — 11 linear inches of rack capacity
Double pusher, space saving design
Polyurethane guide channel system — noise & vibration dampening
Quick change guide channels and pusher
Hydrodynamic support via high volume oil flow into channels
Bosch motion control — dependable and user friendly, allows easy bar feeder parameter changes with remote pendant
Separate floor mounted electric cabinet isolates electronics from vibration

(1) Guide channel set to be chosen by customer. Several sizes to choose from, each handling a specific stock range. See chart on page 36. (spindle liner required if channel set is not lathe’s max capacity)
(1) Universal hard nose and (1) nose I.D. liner specific to pusher
(1) O.D. barstock collet (to be chosen by customer)
Automatic remnant retraction, self centering gripper
Custom lathe cable and interface plugs
Outboard roller steady rest—quick adjust system and super rigid design. Mounted to base of machine to provide maximum support of bar stock and pusher
48 part program memory storage