size | 52" |
Width of Belt | 52" |
Working width – 1300 mm (52”) part feed inlet
Abrasive grinding belt width – 1300 mm (52″)
Roller brush – steel, 1300 mm (52”) wide
Outer rollers feed parts onto powered conveyor belt part carrier
Internal “pinch” rollers keep work in place on conveyor belt
Conveyor belt has controls for fixed or floating mode, height, speeds and direction, 3 hp motor-gear driven
Front inspection port
Drives for abrasive belt and brush roll – four (4) belts each
Two (2) 30 hp drive motors in sound enclosure
2 speed abrasive belt motor, adjustable contact drum height
11” barrel brush includes gantry hoist for removal
Pneumatic cylinder adjustments for each drive
Compressed air required, air flow reducing valve on unit
Set-Matic controller – stick type operator controls
Set up controls (on side) to select deburr modes; speeds, feed belt direction, oscillation of grinding belt and brush
Motor load indicator gauges (2); 440 volt, 60 cycle
Emergency off.
Two (2) exhaust / dust collection ports (belt and brush)
Operation and maintenance manual with drawings