Mitutoyo Crysta Apex S163016 Microcord CMM Coordinate Measuring Machine (2016)
Have one to sell?
ConditionUsed
1 available
The CRYSTA-Apex S is a high-accuracy CNC coordinate measuring machine that guarantees
a maximum permissible error of *E0,MPE = (1.7+3L/1000)μm [500/700/900 Series]. Let's
compare the CRYSTA-Apex S with CMMs offering *E0,MPE of approximately (2.5+4L/1000)
µm. If, for example, the required tolerance on a dimension is ±0.02 mm, then the measuring
machine uncertainty should be no more than one-fifth (ideally one-tenth) of that, i.e. 4μm.
This means that with a general-purpose CMM, when the measured length exceeds 14.8"
(375mm), machine uncertainty exceeds one-fifth of the dimension tolerance in this case. In
contrast, as shown in the figure on the right, with the CRYSTA-Apex S the measurement
uncertainty remains within one-fifth of the dimension tolerance up to 30.2" (766mm).
The higher accuracy specification of the CRYSTA-Apex S, therefore, gives it more than
double the effective measuring range in terms of accuracy-guarantee capability in this case.
*ISO 10360-2:2009
Mitutoyo Crysta Apex S163016 Microcord CMM Coordinate Measuring Machine (2016)
Measuring
range
X axis 62.99" (1600mm)
Y axis 78.73" (2000mm) 118.10" (3000mm)
Z axis 62.99" (1600mm)]
Resolution 0.000004" (0.0001mm)
Guide method Air bearings on each axis
Drive
speed
CNC mode
(Key selector: AUTO Max. moving speed = 693mm/s (27.3"/s) (3D) Max. measuring speed = 8mm/s
CNC mode
(Key selector:MANUAL) Max. moving speed = 236mm/s (9.3"/s) (3D) Max. measuring speed = 8mm/s
Max. drive acceleration 3D: 1.41G (1390mm/s2 )
Workpiece Maximum height 55.11" (1400mm) / [70.86" (1800mm)]
Maximum mass 6,613 lbs. (3000kg) 7,716 lbs. (3500kg) 9,920 lbs. (4500kg)
Mass (including the control device and
installation platform)
20,502 lbs. (9300kg)
[20,613 lbs. (9350kg)]
23,368 lbs. (10600kg)
[23,479 lbs. (10650kg)]
32,628 lbs. (14800kg)
[32,738 lbs. (14850kg)]
Air supply
Pressure 58 PSI (0.4MPa)
Consumption 5.29CFM (150L/min) under normal conditions
Air source 7.06CFM (200L/min) CRYSTA-Apex S comes equipped with a temperature compensation system
that guarantees the accuracy of measurement under temperature conditions
of 60.8 to 78.8 °F (16 to 26 °C). From sensors installed on each axis scale and
working in conjunction with sensors placed on the workpiece, temperatures are
obtained before outputting the measurement result to the controller. Thermal
compensation is applied based on 68 °F (20 °C), taking into account the
workpiece material expansion coefficient. The combined axis scale/workpiece
temperature compensation design used on the CRYSTA-Apex S gives superior
results compared to systems with sensors only on the axis scales.
Hexagon RC1 Control
We use cookies to improve your experience. Privacy Policy.